Best Glue For Bent Wood Lamination

The drawer faces for the desk need to fallow the same curve as the desktop.

Best glue for bent wood lamination.

Then put against the original form. Unfortunately it is not particularly rigid and does not have much open time. This is a perfect example of a situation where bent lamination is a good choice. Bending wood part ii bent lamination.

With domestic wood laminations the simplest and least visible glue is pva polyvinyl acetate yellow glue. There isn t one adhesive ideal for every application. You might want to read a separate article on types of glue for laminating and choose the best glue for each procedure. Because bent laminations are under constant stress they require glue that sets hard.

What is the best glue for laminating wood. 10 layers 1 8 at about 5 radius after the glue had cured for 24 hours on the form the parts were laid aside for at least a week. Bending wood part ii bent lamination. The wood used was hard maple one of the more difficult from both the glue adhesion and bending stiffness.

Yellow glue sets soft and fast. If you are using yellow glue this does not leave a lot of time. A couple of glues that seem to be good choices for bent lamination are pro glue unibond 800. The first is the one woodworkers use to glue together planks of wood to form a wide surface for a.

The laminate parts need glue between each layer and to be clamped to the form before the glue dries. I need to make a bent lamination for these faces that are 17 wide and range from 12 to 9 tall. The finish spec is high density plastic laminate. Quite a while back i did a series of glue tests on bent laminations.

The term laminating wood can be used to refer to three different procedures and the one that is good for one operation isn t necessarily suitable for others. Pictured left you can see a closeup of one of the rockers on my maloof inspired rocker. While resorcinol has a. It is also prone to glue creep a phenomenon in which the cured glue creeps out of the laminations over time resulting in unsightly raised glue lines.

I realize there are other choices out there and i m not locked in to these two choices. In doing research before attempting my first bent lamination i m starting to look at the appropriate glue choice for the project. The concept is actually pretty simple. What would be the best wood to use on this bending project.

Standard wood glue is not the best choice for bent laminations. Epoxy urea resin resorcinol and polyurethane are all good choices for bent laminations. Of these four glues urea resin and resorcinol achieve the most rigid glue line when cured. Adding a maximum of 8 powdered cornstarch by volume makes the glue more rigid and controls springback.

I have found that a mix of 1 part water to 4 parts glue spreads quick. So your best bet with heavilyt curved parts is to either steam bed the material to shape or do a bent lamination. The glue lines from jumping out.